The work is devoted to the study of algorithms of control subsystem as part of the integrated onboard control system of the aircraft and used in the final part of the trajectory. Algorithms of control subsystems are synthesized on the basis of the theory of optimized delta-transformations of the second order using the principle of the inverted pendulum on a cart. The studies based on the simulation using the developed software model, allowed to estimate as the impact dispersion, and the contribution to it of various subsystems.

Keywords: terminal control, aircraft, on-board integrated control system, optimized delta transformation of the second order, autonomous short range radionavigation system, simulation, software model

In this paper the technology of repair of ground water retaining structures soil mixture improved quality with and without soil mixture install.Use soil mixture , improved sharps and ensure the return of ashes (repaired ) slopes and ridge structures of high strength (up to 13-15 MPa) and water resistance , thus increasing the effectiveness and quality of the repair work and increased resistance to the elements of the structures induced defect . The presence of the bran soil mixture not only enhances the strength of 30-40% , but also gives a significant increase in water and frost (20-30 %), which prevent or substantially reduce the infiltration of water through the filtration body water retaining structures , since high strength and frost soil-concrete being laid on a slope ( in the recovery slope failure ) and groove (at soil dumping and capacity to or in excess of the design marks ) will reliably protect the body of the dams ( dams ) of the drawdown , erosion , buckling , suffusion , and other deformities.

Keywords: technology, dribble feed , soil mixture, sift, cement, fly ash, dam, construction and repair operations, soil mixture installation, factors plan of the experiment, the regression equation

In the article authors examine specificities of internal components behavior changing in fiber-optical cable under influence of strong variable uniform electromagnetic field. There are some process variations proposed for describing of obtained results.

Keywords: fiber-optical cable, electrothermal degradation, kevlar, conductivity, open fiber-optical cable, partial discharges, water treeing

The article describes peculiarities of modern syntax parser systems and problems originating in text analysis. As a result of comparative analysis the authors propose a unified approach to processing of unstructured texts in Russian and English which combines morphology and syntax processing. The developed syntax analysis system, using verbs’ valency dictionary, samples of minimal structural schemes of sentences and samples of conjunctions, allows choosing predicative structures of sentences in the text, realizing initial semantic analysis due to semantic content of predicate’s actants and building trees of syntactical subordination of sentences. The derived trees hold elements of tree of constitutives and tree of dependences. The proposed samples and rules organization allows resolving some of the problems of modern parsers. And the use of verbs’ valency dictionary allows reducing the number of sentences syntax analysis variants.

Keywords: automatic text processing; syntax parser; morphological analysis; structural text elements

In this work experimentally investigated the possibilities of the new method of obtaining adjustable roughness on metal surfaces electrothermal influence of mobile cathode spots in vacuum arc discharge. Presents the results of processing of various surfaces using this method. Proposed working modes of processing of metal surfaces with the aim to receive as minimum and maximum roughness.

Keywords: roughness of metal surfaces, vacuum arc discharge, cathodic spots

In the present work proposes a specified description of potential functions when the free spreading  in the two-dimensional turbulent flow of planning. In contrast to previous decisions, new parameter satisfies the continuity of flow when the flow flowing  from rectangular tubes on the discharging  track  

Keywords: final line of motion, lines of equal potential, horizontal rectangular tube, diverting from the mainstream flow

In this paper is offered hydraulic sensor to measure the kinematic, power and energy parameters. Developed scheme and the principles of the hydraulic sensor.  Identification  on the special flow lab with real modes of the device is determined by its performance in different conditions. Approximation of the results received dependences flow and pressure drop characteristics on the speed and entrance pressure, allowed more correctly assess and describe the operation of the hydraulic sensor over the entire range of speed and entrance pressure.

Keywords: hydraulic sensor, spilling method, flow and pressure drop characteristics, multifunction control unit.

An analysis of the problem of increasing the efficiency of the functioning of the logging trucks for hauling timber to the lower timber depots and consumers. Proposed technical solutions for of raising cross-trains in complex natural and industrial environments.

Keywords: Active semi-trailer used forestry, passableness, prosary operation.

The temperature dependencies of the main parameters of p-channel MOSFET model in a temperature range 20 ... 300 K are measured. The universal formal four-parametric model, which allows approximating all experimental temperature dependencies with the relative error less than 1 % is proposed. The model is intended for the MOSFETs which are applying in low-noise amplifiers of the radio-receiving devices of an optical and infrared range on astronomical satellites, radio telescopes and space observatories. The presented results can be used to simulate the temperature modes of MOSFET amplifiers in SPICE-type electronic simulators. The solution of this problem will predict uptime device when the temperature changes in the cases of emergency or extraordinary situations and also will allow optimizing the choice of refrigerant and increasing the reliability of the amplifier in the conditions of cryogenic temperatures.

Keywords: MOSFET, MOSFET parameters, cryogenic temperature, parameters measurement, temperature dependencies

The problem of efficient use of lubricants in service of railway technology, based on a system for the collection of used oil and re-use them after regeneration. The analysis of the consumption of lubricants and identify possible potential resource - the volume of used oil and the resulting volume of recovered oil.

Keywords: oils, operation of transport equipment, used oil, used oil collection, regeneration

A mathematical model of a surface mini-ship "Neptune", including a mathematical model of the actuators. Used to identify the parameters of the mathematical model. analysis of stability and controllability of surface mini-vehicle for its mathematical model.

Keywords: mathematical model, surface mini-ship, handling, stability

The method of digital parametric measurement of the phase shift of signals with slowly varying amplitudes of the same slowly varying instantaneous frequencies was proposed. The numerical simulations and experiments on the developed hardware and software system were carried out. The error of measurement the phase difference of harmonic signals in the experiments were not more than  0,00001 radian. The method can be used in applications where the measured value is expressed in terms of the phase difference of quasi-harmonic signals.

Keywords: quasi-harmonic signal, phase shift, real time measurements, hardware and software system

In this paper we propose an approach to the implementation of the automatic control system of autonomous unmanned surface vessels on the example of a surface mini-ship "Neptune". Synthesized autopilot algorithms based on the theory of control of dynamic objects, developed by prof. Pshihopovym. A program of mathematical modeling. simulation results, which confirm the correctness of the proposed algorithms.

Keywords: autopilot, surface ship, mathematical modeling

In this paper we propose an approach to the implementation of the automatic control system of autonomous unmanned surface vessels on the example of a surface mini-ship "Neptune". Synthesized autopilot algorithms based on the theory of control of dynamic objects, developed by prof. Pshihopovym. A program of mathematical modeling. simulation results, which confirm the correctness of the proposed algorithms.

Keywords: autopilot, surface ship, mathematical modeling

In this paper a systematic study of individual single-walled and multi-walled carbon nanotubes was performed by Raman spectroscopy and high-resolution electron microscopy. We have presented the geometrical and electronic structure analysis on the examples of two tubes: individual single-walled and double-walled nanotubes. The role of different environmental effects and their influence on the final structure assignment are discussed. Moreover, we have shown that the Raman spectroscopy gives reliable estimations of the nanotube diameters and the conductivity. Given a non-destructible character of Raman spectroscopy, we may conclude that it is one of the most efficient methods for structure analysis of carbon nanotubes.

Keywords: Carbon nanotubes, Raman spectroscopy, electron microscopy